5th Gen 4Runner Third Brake Light Housing | Diode Dynamics SS10 Chase Light Mount

A clean chase light install on your 5th Gen, without wiring gymnastics.

There are plenty of ways to hang an SS10 off the back of a 4Runner. The problem is never the bracket, it's the wiring. Every one of those positions means routing power the length of the vehicle, fishing through the headliner or down a pillar, and hiding a run you'd rather not look at.

This housing puts the light where the wiring already is. It's a direct replacement for the factory third brake light, so you're tapping into the rear harness right there instead of running leads across the whole truck. Shorter run, fewer pass-throughs, nothing visible.

The light sits flush, centered, and looks like it left the factory that way.

I designed this because it didn't exist. As far as I know, this is the only direct-replacement SS10 chase light housing available for the 5th Gen 4Runner.

What you get

• Direct swap for the factory third brake light. No drilling, no cutting, no permanent modification.
• Pocket sized to the Diode Dynamics SS10, with clearance for the light's connector
• Reuses factory mounting points. The SS10's included universal brackets aren't needed.
• Note: Chase light not included

Need the light?
This housing is built for the Diode Dynamics SS10 LED Chase Light, a 3-in-1 unit combining an amber chase light with 20 programmable strobe patterns, a red brake light with SafetyStrobe modes, and a high-output white reverse light. It's IP69K rated and made in the USA. You'll need to source it separately.

Fitment
Toyota 4Runner, 5th generation [2010-2024, confirm your year range]

Install
Roughly 90 minutes with basic hand tools. Install video coming soon.